Update defconfig.esp32p4

Author: Jason2866

configs/defconfig.esp32p4

@@ -1,36 +1,8 @@
 CONFIG_IDF_EXPERIMENTAL_FEATURES=y
-
-CONFIG_NEWLIB_NANO_FORMAT=y
-
-# Enable LP Core
-CONFIG_ULP_COPROC_ENABLED=y
-CONFIG_ULP_COPROC_TYPE_LP_CORE=y
-CONFIG_ULP_COPROC_RESERVE_MEM=8192
-
-CONFIG_ESP_DEFAULT_CPU_FREQ_MHZ_360=y
-CONFIG_COMPILER_ORPHAN_SECTIONS_PLACE=y
-# CONFIG_ESP_TASK_WDT_CHECK_IDLE_TASK_CPU1 is not set
-CONFIG_LWIP_TCP_SACK_OUT=y
-
 CONFIG_SPIRAM=y
 CONFIG_SPIRAM_SPEED_200M=y
-CONFIG_SPIRAM_XIP_FROM_PSRAM=y
-CONFIG_SPIRAM_ALLOW_BSS_SEG_EXTERNAL_MEMORY=y
-CONFIG_SPIRAM_ALLOW_NOINIT_SEG_EXTERNAL_MEMORY=y
-CONFIG_SPIRAM_BOOT_HW_INIT=y
-CONFIG_SPIRAM_BOOT_INIT=y
-CONFIG_SPIRAM_PRE_CONFIGURE_MEMORY_PROTECTION=y
-
-CONFIG_RTC_CLK_CAL_CYCLES=576
-# CONFIG_ESP_SLEEP_GPIO_RESET_WORKAROUND is not set
-CONFIG_FREERTOS_WATCHPOINT_END_OF_STACK=y
-CONFIG_FREERTOS_TIMER_TASK_STACK_DEPTH=3120
-CONFIG_CACHE_L2_CACHE_256KB=y
-CONFIG_CACHE_L2_CACHE_LINE_128B=y
-
-# RGB Display Optimizations
-CONFIG_LCD_RGB_ISR_IRAM_SAFE=y
-CONFIG_LCD_RGB_RESTART_IN_VSYNC=y
+# CONFIG_ESP_TASK_WDT_CHECK_IDLE_TASK_CPU1 is not set
+CONFIG_LWIP_TCP_SACK_OUT=y
 
 CONFIG_SLAVE_IDF_TARGET_ESP32C6=y
 CONFIG_ESP_SDIO_BUS_WIDTH=4
@@ -43,13 +15,10 @@ CONFIG_ESP_SDIO_PIN_D2=16
 CONFIG_ESP_SDIO_PIN_D3=17
 
 #
-# BT config
+# RGB Display Optimizations
 #
-CONFIG_BT_ENABLED=y
-CONFIG_BT_CONTROLLER_DISABLED=y
-CONFIG_BT_BLUEDROID_ENABLED=n
-CONFIG_BT_NIMBLE_ENABLED=y
-CONFIG_BT_NIMBLE_TRANSPORT_UART=n
+CONFIG_LCD_RGB_ISR_IRAM_SAFE=y
+CONFIG_LCD_RGB_RESTART_IN_VSYNC=y
 
 #
 # Wi-Fi Remote
@@ -65,9 +34,10 @@ CONFIG_ESP_HOSTED_ENABLE_BT_NIMBLE=y
 CONFIG_ESP_HOSTED_NIMBLE_HCI_VHCI=y
 
 #
-# PPP
+# BT config
 #
-CONFIG_LWIP_PPP_SUPPORT=y
-CONFIG_LWIP_PPP_NOTIFY_PHASE_SUPPORT=y
-CONFIG_LWIP_PPP_PAP_SUPPORT=y
-CONFIG_LWIP_PPP_ENABLE_IPV6=n
+CONFIG_BT_ENABLED=y
+CONFIG_BT_CONTROLLER_DISABLED=y
+CONFIG_BT_BLUEDROID_ENABLED=n
+CONFIG_BT_NIMBLE_ENABLED=y
+CONFIG_BT_NIMBLE_TRANSPORT_UART=n